I had to move my steering rack forward to install new control arms and now I cannot slide the column back into the rack. Any help? I did align it and try to slide it over but would not move.This is as far as i can go before hitting the imprint.
So I’m looking at ordering a built shortblock if I can’t find a shop to use/I like once I move to San Antonio this month.
What online builders have you used that you’re happy with? I’m going to absolutely avoid MMR as there are just too many negative reviews on them.
I’ve been looking at...
I picked up a new edge with an On3 (single turbo) kit installed on it and I'm currently replacing the engine. I noticed that the drain line for the turbo is going to the front of the oil pan and the line goes below the oil pan fitting a bit before finally terminating. It looks like PO was...
After installing an aftermarcket steering wheel the speedo quit working. Deleted the horn/cruise control. Would the new wheel cause the VSS to fail? All wires are capped and tucked away. I also got rid of the radio.(radio harness isn't plugged into a radio is all.)
-Thank you in advance.
I recently decided to swap the engines due to a thrown rod.
I am swapping with the 2011 crown vic PI but ran into an issue... The fuel rail on the crown vic has 1 connector and the mustang has 2.. is there any way around this so I could use the flex fuel from the crown vic?
The injectors are...
A forum community dedicated to Ford Mustang owners and enthusiasts. Come join the discussion about performance, production numbers, VIN decoders, modifications, troubleshooting, power adders, DIY tutorials, and more!