Ford Mustang Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
71 Posts
Discussion Starter #1
The grommets I have in my valve covers currently have 1" holes. Does anyone know where I could get a 1" to 5/8" 90? Can be plastic. It will be going to my oil breather tank. I dont want to run one of those giant push in styles unless there is a reason to.
 

·
Registered
Joined
·
71 Posts
Discussion Starter #2
Could do AN fittings but the valve covers are powdercoated already and I dont want to drop $150 on my breather setup.
 

·
Registered
Joined
·
39 Posts
I put an fuel cell bulk heads in mine with nylon washers and pinged the nut so it couldn't back off. 12an fit the breather hole perfect.
 
1 - 3 of 3 Posts
Top