Ford Mustang Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
863 Posts
Discussion Starter #1
I was gonna go a few different directions with my car and come across a few deals I couldnt turn down, I am gonna get my car back on the street for now and build a dart block motor on the side.

I picked up a 302 complete motor, 5,000 on the rebuild. I am gonna put some head studs and good gaskets. I will still prolly girdle it and freshen it up. It has the following:

Trick Flow Track Heat Intake
Trick Flow 170s-How are these heads???
Haredened Push Rods
1.6 Roller Rockers
E-Cam-I have heard they arent good with a turbo???
BBK 75mm Throttle Bottle

On3 Perfomance 76mm .81ex with big intercooler
Does anyone know if the On3 Turbos are MPs?
I have a A1000, Reg, Rails and sumped tank with 60lb injectors I will be running.
It will be a 5 speed car for now with 327s and a 27x10.50 tire
Full Suspension

What are your thoughts on this?
 

·
Registered
Joined
·
2,937 Posts
id swap the e cam for an f cam. they have been known to make lots of piwer in a turbo setup
 

·
Registered
Joined
·
2,937 Posts
oh, and the on3 turbos are a knock off of the Master Power. Some have had good luck with them, others not so much. but they can be rebuilt for about $30!
 

·
Registered
Joined
·
863 Posts
Discussion Starter #4
FOR SURE!!! Yea, looks like I am ordering my kit next week and start getting my build going. Should be a pretty strong running car. Will post of pictures
 
1 - 4 of 4 Posts
Top