Tranny cooler routing
Join the discussion
Recommended Reading
-
PTV Contact After Degreed Cam Install?
5.0/5.8 Engine TechHey fellas. Working on the motor out in the shop today, thanks to mandatory home time. I’m having problems with my cam install in my 302/11r build. I’m measuring for my pushrods and I’m having PTV contact after degreeing the cam in. I’ve tried it both 2 advanced and straight up. It barely...- 20
- 1K
-
64Cometkid · updated
-
Pro m mass air meter on c&l housing
5.0/5.8 Engine TechHey guys, i have a 73 or 76 c&l housing and wondering if i can remove the pro m meter from its 3 inch tube housing and install on c&l. Reason is im procharged and need the shortter housing. Thx- 18
- 632
-
87 notchfox · updated
-
Bad Injector.. What Symptoms?
5.0/5.8 Engine Techi have a feeling i have a stuck injector, what kind of symptons would a stuck injector have? ****ty driveability? would it cause a code?- 12
- 27K
-
AFR 8019 springs or Equivalent
5.0/5.8 Engine TechWhat is the best price and place to buy a set of 16? Maybe the gurus will chime in. What Is a Equivalent spring that I could use with the same diameters as the factory 8017 spring that would be sufficient for the comp 35-522-8 cam- 11
- 342
-
10SEC93GT · updated
-
GT40 Combo and need to loose 6 to 8 HP
5.0/5.8 Engine TechI have a 302 with GT40 (Iron) heads, B cam, Holley 600 DP, Edelbrock Performer RPM Intake, BBK 1 5/8 shorties, X pipe (no cats) and Dynomax Race bullet Mufflers. I had the Ignition timing set at 10 degrees BTDC at idle. When I dynoed the car it put down 273 RWHP and 294 RWTQ. I am allowed a...- 48
- 3K
-
Britboy · updated
Join now to ask and comment!