Ford Mustang Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
5,235 Posts
Discussion Starter #1
i didn't get this bolt because i got the pulleys used. It says on their website that its 12mm by 60mm. I got a 12 by 70 and a 12 by 50. will either of these work. I know i dont have to tighten it very much, as its just a starter, but will either of the ones i got work? I also have a puller and some high temp sealant but no breaker bar, do i need one? thanx in advance
 

·
Registered
Joined
·
545 Posts
The long bolt with the kit is to start pulling the pulley back on the crank. As long as the thread rate is the same, I would think it is ok. A breaker bar will come in handy when trying to get the crank bolt off and tightening it down.
 

·
Registered
Joined
·
1,721 Posts
99svt32v said:
some one also told me that i had to use a new crank bolt is this true? I think i will be ok using the old one

once you get the pulley on, take the long bolt out and use the stock crank pulley bolt. i reused mine, it's fine. torque that bolt down to specs. the torque spec is on steeda's website, check it out. hope this helps.
 
1 - 6 of 6 Posts
Top