Ford Mustang Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
175 Posts
Discussion Starter #1
I live in Baltimore, MD and have experimented with several shops for work and tuning but I was wondering if any knew of a shop that would stand out above the rest. I am looking to get my car tuned and gone over with a fine tooth comb. Any suggestions?:confused:
 

·
Registered
Joined
·
283 Posts
talk to Brian or Bill at E.L.D. Performance now located off of I-97 in Millersville you will hear people bashing them I have been going there for about 10 years and never once had any problems he now has an in house dyno and can do most anything needed give them a call 410-451-0202
 

·
Registered
Joined
·
90 Posts
grnnv306 said:
I live in Baltimore, MD and have experimented with several shops for work and tuning but I was wondering if any knew of a shop that would stand out above the rest. I am looking to get my car tuned and gone over with a fine tooth comb. Any suggestions?:confused:
PSI in Glen Burnie . They have a Mustang Dyno and Jeff is a good tuner .There are other shops that use PSI like JPC just to name one. Were back now so call Jeff at 410-766-7774.
 

·
Registered
Joined
·
83 Posts
I wouldn't personally take my car anywhere but McNews Automotive in Dillsburg PA. It's a little bit of a haul (hour and fifteen minutes from Bmore) but Ray is an excellent tuner and has done hundreds of Mustangs just in the past few years (since the in-house Dynojet was installed) and countless others over the past twenty some years he's been working on them. My vote will go to Ray 100% of the time.

Best part is, Ray is the type of guy who won't sell you anything that he doesn't feel won't work for your car (or at least will try to talk you out of it.) He doesn't even bother doing many mail order tunes since anyone knows that it's damn near impossibly to tune even a bolt on car without strapping it down and at least doing a few baseline runs.

www.mcnewsautomotive.com

Nate
 
1 - 8 of 8 Posts
Top