Ford Mustang Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
383 Posts
Discussion Starter #1
I am in the process of installing Maximum Motorsports front coilovers and have run into a snag. After (finally) getting everything disassembled, I noticed that one of my Koni struts has an upper flange like the Tokico's. I am assuming that this needs to be removed as shown in the instructions, but I wanted to make sure before I did something I shouldn't. Has anyone run into this situation before?

Al H
 

·
Registered
Joined
·
1,698 Posts
Are you sure it doesn't specify in the MM instructions? I would contact MM themselves, they have awesome customer service and should get back to you by tomorrow.
 

·
Registered
Joined
·
383 Posts
Discussion Starter #4
Thanks for the reply's. I was able to get the flange off with a dremel tool and a hammer. Got the project finished today and everything's good.

Al H
 
1 - 4 of 4 Posts
Top