Ford Mustang Forums banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
327 Posts
Discussion Starter #1
MHS Stage 2 PI 2v Cams

Set of Modular Headshop (MHS) heads and cams for a 2v engine.

Heads have Stage 3 port job with 1mm oversize valves with their stage 2 NA valvetrain.

Cams are Stage 2 N/A PI grind and were degreed by MHS.

I ran these for a total of 30k miles, approx 20k miles in N/A form, and made around 300rwhp. I then added a Kenne Bell 2.1 supercharger, running 10psi of boost and made between 400-450rwhp depending on the tune for 10k miles. Valvetrain never skipped a beat, running out to 6500k rpm in N/A form and 6k rpm when supercharged (stock bottom end).

I would like to sell the heads and cams as a set, but will split them up if needed.



I also have a set of low mile CMS Stage 3.5 Blower cams for sale in another thread ($450 Shipped OBO)



UPDATE: MHS Heads have been sold. I still have their Stage 2 N/A PI cams for sale. Asking $350 Shipped OBO

SOLD
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top