Ford Mustang Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter #1
Does anyone make any motor plates that are the right width for a LSx swap in a Mustang chassis? I had a car with some Skinny Kid motor plates and a windsor based motor and they worked great.
 

·
Registered
Joined
·
281 Posts
i would like to know also, i have a buddy who made a card board template and sent it out to get made looked really good when it was done, very simple and clean. he can have the motor in and out in half the time. he still has a aje k member though
 

·
Registered
Joined
·
336 Posts
aeicnc.com

he makes a few different motor plates for LSx engines...

totally dependent on which chassis you have(I know they are all the same basically, but small differences in where and how its going to mount...)

I'm planning on doing one IF I decide to Jump into a Mustang with my current Crazy setup.
 
1 - 4 of 4 Posts
Top