Ford Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,152 Posts
Discussion Starter #1
what if i got a hold of some bare heads milled them to raise the CPR/ ported and polished or maybe extrude honed them and got a PHP intake. What kinda power would it produce and what would that run as far as cost?:evil: Summer is coming and it's once again time to let the green start flowing
 

·
Registered
Joined
·
1,006 Posts
I had a Stage 3 p&p, 5 angle valve job to the heads and milled and that alone neted me a 25 rwhp and thats because I dont have a cam with enough lift to take advantage of the cfm numbers (291 intake, both runners) at .650 valve lift, or I would really be putting some mean hp numbers. I have 11:5.1 pistons so thats helping me. But with the mod. intake and the heads you may see 35 to 40 rwhp, with a cam and a tune, 50 to 60 rwhp...DA Snake boy!!!
 
1 - 2 of 2 Posts
Top