Ford Mustang Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #2
I think i did it right...but most likely not because the car still wouldnt start.
Cam Position Sensor looks like this:
cps1.jpg


And this is where i rotated the crankshaft to about 26 degrees ATC i think. :
cps2.jpg


I rotated the crankshaft 180 degrees but it put the half-moon of the sensor on the other side so i put it back where it was and it still didnt start.
.Maybe i need the half moon on the other side.
 
1 - 4 of 4 Posts
Top