Ford Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3,013 Posts
Discussion Starter #1
Well, finally finished my custom brake duct backing plate for my TCE/Coleman 2-piece rotors.
The slot at 6:00 is for the Griggs control arm flange to poke thru (and extra drilled hole was an oops). The inner/outter rings are to help seal the backing plate against the rotor, as well as provide stiffening for the backing plate. There was a ribbing welded to the outside towards 11:00 to proved support for that mounting tab also.

Photos:






 
1 - 2 of 2 Posts
Top