Ford Mustang Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
It is black with a black covertable top, and grey interior. All the interior is in perfect shapeas well as the body. The motor is a 302 roller block that has been bored .40 over with keith black pistons, the work on the block was done 03/05, msd 6a igition box with blaster 2 coil and msd tach adapter, has a holley 600 carb, with a 2" spacer, eddlebrock air cleaner, flowmaster with turn down dumps, has a larger cam in it that went to a 351w, the posi is new, new wheel bearings in the front, new tie rods in the front, new convertable top motor, stock rear end gears. I am the third owner of the car, this is one that hasne been around the block a few times, and wire harness torn up everything electrical woprks on this car all windows, the top does not leak. The car sets on factory 10 holes. The car has strong bottom end power to it. This car is a coupe body stlye with a convertable top, no gt kit at all. Have dyno sheet from it last run before mods were added and have alot of reciepts for parts and work that has been done over the years.

The bad the heater core is out in it. Good thing is I have a brand new for it for the next buyer.

$3500.00 obo

pics....

http://i6.photobucket.com/albums/y2...cduty/4eye3.jpg

http://i6.photobucket.com/albums/y2...cduty/4eye2.jpg

http://i6.photobucket.com/albums/y2...cduty/4eye1.jpg


The car is currently in jacksonville, nc I also can be reached by email non_[email protected]
 
1 - 7 of 7 Posts
Top