Ford Mustang Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
631 Posts
Discussion Starter #1
I'm trying to wire up my DCC fan controller to my 95 e-fan but I am not too sure which wire is the low speed and which one is the high speed wire on the fan plug. There's...

Black- ground(assuming)
Red w/orange stripe- ???
Orange w/grey stripe- ???

I searched the forums but all the post I found were just people arguing about stuff :mad:
 

·
Registered
Joined
·
23,232 Posts
Was gonna tell you

but your comment, clearly means you need more search time.
 

·
Registered
Joined
·
25 Posts
I included the page of the Ford EVTM book that identifies the colors for the fan wires.
The Red/Orange stripe is the low speed.
The Orange/Light Blue stripe is high speed.
And the Black is the Ground.

I honestly don't know why someone would post a reply just to ridicule another member but.............

20171015_163920 by i.e.427, on Flickr
 

·
Registered
Joined
·
631 Posts
Discussion Starter #4
I included the page of the Ford EVTM book that identifies the colors for the fan wires.
The Red/Orange stripe is the low speed.
The Orange/Light Blue stripe is high speed.
And the Black is the Ground.

I honestly don't know why someone would post a reply just to ridicule another member but.............

20171015_163920 by i.e.427, on Flickr
Thank you and yeah, that's very interesting :rolleyes:
 

·
Registered
Joined
·
3,575 Posts
The center pin on the fan is the low speed, which you don't use with the DCC Controller.
 
1 - 5 of 5 Posts
Top