Ford Mustang Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
84 Posts
Discussion Starter #1 (Edited)
I have a 1986 mustang gt/lx hatchback.Fully forged motor built for nitrous.It drives around pretty good for a car with a big cam.Can drive to and from the track with no worries.Interior is pretty decent for a 86 and it has power seats out of a 99-04 mustang.Underbody is very clean not rusting out like most older foxbodys.Im looking for cash or trades.No stupid trades or lowball offers 513-709-9727 looking for ls1 car,foxbody coupe, The only things it has wrong with it are.Fuel sending unit causing the gas gauge to not work.The shocks for the hatch are bad,and the antenna is broke off.Other then that really solid car especially for a 86.The motor was built by bischoff racing engines.It was tuned by cincy speed.It ran an 11.70 with the old clutch slipping pretty bad.Im located between cincy and dayton ohio also.

Anderson n91 cam and matching springs
Bishoff tuned 202-160 heads
302 ford racing block bored .30
306 done by bes racing engines
11-1 probe dome pistons
75 mm throttle body
80 mm mass air meter
36lb injectors
centerforce stage 2 clutch
Sub frame connectors
Whole floor board of car is rhino lined control arm bushings will never need replaced again
New alternator
New battery
Msd distributor
Msd plug wires
New NGK v power racing plugs
Fuel pressure regulator gauge
Recent oil change using royal purple oil and k&n oil filter
Weld racing rims
BFG drag radials in rear and new front skinnys(rears are getting old) After market dif cover
Coil springs and shocks in rear
No rips in interior
Converted to mass air
2002 mustang gt electric seats
Monster tac gauge w shift light
Scat connecting rods
Ati super damper
Edelbrock victor jr aluminum heads
Harl and sharp roller rockers
Engine fastener set
Scat crank forged
Tremec tko 600 5 speed trans
Sfi approved lakewood bell house
8.8 rearend 4.10 gears
Fidanza flywheel
31 spline moser axles
31trackson lock for posi unit
Mac gertel
Motorsports spring racing
Lakewood drag shocks 50/50 rear 90/10 front
Mac long tube headers
Mac h pipe
Motorsports aluminum drive shaft
Motorsports safety loop
Hurst shifter brand new dual flowmaster super 44s



fox by 5-6 cars by 130(cold dr's and not really launching being that he was on streets,the 3v ran a 12.9 on street tires)







 

·
Registered
Joined
·
232 Posts
Did I miss the price? Have always wanted to get back into a 4 eye, always loved them
 

·
Registered
Joined
·
84 Posts
Discussion Starter #4
Did I miss the price? Have always wanted to get back into a 4 eye, always loved them
damn im stupid didnt even put the price 8500 obo. make me an offer if your serious about it.The motor and the rest of the performance parts have around 3900 miles on them.
 

·
Registered
Joined
·
132 Posts
86

Hi beautiful car! I have a car u may be interested in maybe not but worth a shot I have always loved the 86 stangshad 7 of em starting in high school. I now have a 96 SVT Cobra with less than 46k miles on it I am planning to sell or trade for a 4 eye car if Ican find a nice one that is interested in the 4 cammer cobra's. If not good luck its bad ass!! Later ADAM
 

·
Registered
Joined
·
84 Posts
Discussion Starter #6
Hi beautiful car! I have a car u may be interested in maybe not but worth a shot I have always loved the 86 stangshad 7 of em starting in high school. I now have a 96 SVT Cobra with less than 46k miles on it I am planning to sell or trade for a 4 eye car if Ican find a nice one that is interested in the 4 cammer cobra's. If not good luck its bad ass!! Later ADAM
I might be interested.Is it stock? can you send some pics to [email protected]
 
1 - 8 of 8 Posts
Top