(CA) 5.0 Stroker (333) Coast Kit, Pro-M Efi
Selling my fully built mustang 5.0 stroker engine. Located in Northern CA.
Specs below: Looking to get $4200 obo.
333 ci
88-93 5.0 short block bored .40 over
Trickflow twisted wedge heads aluminum 170s
Forged Mahle high compression pistons for tw heads
Coast performance forged crank/rods
Block girdle w/high capacity oil pan
Trickflow 1.6 rockers
Tfs2 hydraulic roller can
TF damper
3g alternator
Standard volume water/oil pump
ARP hardware throughout
TF Aluminum Intake
75mm bbk tbody
Upgraded clutch/flywheel
Also have a Pro-M Efi for a 93 mustang that can go with it as well. Its the Coil-On-Plug setup. 2500 with injectors, maf, data sheet, coils, dist cover etc.
Has been started up and idled, but never driven. Fired right up and sounded solid during idle. This engine is ready to drop in and go.
Hit me up with any specific questions, but please don’t waste my time.
Selling my fully built mustang 5.0 stroker engine. Located in Northern CA.
Specs below: Looking to get $4200 obo.
333 ci
88-93 5.0 short block bored .40 over
Trickflow twisted wedge heads aluminum 170s
Forged Mahle high compression pistons for tw heads
Coast performance forged crank/rods
Block girdle w/high capacity oil pan
Trickflow 1.6 rockers
Tfs2 hydraulic roller can
TF damper
3g alternator
Standard volume water/oil pump
ARP hardware throughout
TF Aluminum Intake
75mm bbk tbody
Upgraded clutch/flywheel
Also have a Pro-M Efi for a 93 mustang that can go with it as well. Its the Coil-On-Plug setup. 2500 with injectors, maf, data sheet, coils, dist cover etc.
Has been started up and idled, but never driven. Fired right up and sounded solid during idle. This engine is ready to drop in and go.
Hit me up with any specific questions, but please don’t waste my time.