||LinkBack||Thread Tools||Display Modes|
On3 351w downpipe fitment with PA bellhousing, qa1 k member
Wondering if anyone has any input on this. With my Windsor and the on3 kit this down pipe isn't going to fit with the big after market PA bell. I'm thinking my only options are through the fender or hood which I really really don't want to do. Not sure if I can cut into the firewall?? Any suggestions or experience with the same issue would be appreciated. Thanks in advance!
Trader Feedback: (4)
Join Date: Dec 2012
Location: Lampasas, Tx
I don't have a 351 or a aftermarket K, but I have a 302 with built AOD I just completed. My downpipe was tight and wouldn't go down between the frame rail and bellhousing. I had to loosen the passenger motor mount and trans mount and jack the engine up a bit and then it slid down in. This was with the downpipe blanket on also.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Want To Buy Bellhousing NEEDED for 351w||superchargedv8||Drivetrain Parts||2||07-20-2013 09:54 PM|
|on3 bellhousing fitment 351w kit||turbotrav||Turbochargers||0||08-01-2012 09:50 AM|
|For Sale QA1 k member and control arms 79-95||tb94||Suspension||24||05-11-2011 06:59 PM|
|UUGGHH! QA1 k member install problem!||COP_STANG||General Mustang Tech||7||05-05-2011 05:23 PM|
|Hal QA1 K member ??? HELP??!!||92 coupe||5.0/5.8 Engine Tech||5||01-08-2002 12:57 AM|