Ford Mustang Forums banner

edelbrock e-205 heads

3K views 3 replies 3 participants last post by  Caprimaniac 
#1 ·
anyone know much about the e-205 heads or used them thinking of using them on a 383 76mm combo that may go twin 76s?
 
#2 ·
there was a thread on here about them awhile ago....they were junk heads made to compete with the procomp heads, which are knock-offs of the original eddys.....weird huh!!!
 
#4 ·
Did anyone of you get these heads?

I've talked to Edelbrock and they've assured me these (E-205) heads are different castings than the E- street which have seen some negative feedback on the forums.

I'm thinking of getting a set of E-205's, port well, use the valves, upgrade to 7/16" rocker studs, use the hardware I have lying around and use on a 7000RPM 306.

This is a somewhat budget rebuild...

Any input on the heads would be appreciated.

RS
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top