Ford Mustang Forums banner

1984 Mustang for sale CLEAN!!

1K views 10 replies 9 participants last post by  88CrownVic302 
#1 ·
Hi I have a 84 mustang for sale , this is a CA car and is super clean.
It has a DSS 306 bullit and has been converted to F.I.
here is a list of parts , also it has a new paint job, the car ir 75% done and needs to be finished.
GT 40 intake polished upper and painted lower.
289 HiPo heads ported and polished 1.94 intake 1.60 exaust stainless manley swirl cut valves.
10.5 to 1 compression, Motor sport B-cam and roller valvetrain, Omega rockers
BBK 70mm TB and spacer Pro-m 75 mm bullit and 24# injectors.
Balanced and blue printed short block FMS roller timing chain.
new water pump , and altenator.
complete new brakes from master cyl to pads.
A9l computer and FMS wire harness.
Lentech strip terminator trans with a 10 inch 3400 stall converter.
B&M hammer shifter.
FMS alum drive shaft.
3:73 gears in a 8.8 inch rear.
Full lenth headers and Mac pro dumps.
The interior has new recovered seats and a new dash pad, also new carpet
and floor mats.
Auto meter monster tach.
grantelli tubuler K- member, and coil over set up. and sub frame connectors
There is so much done I am forgetting some things, The car ran 12.0 on street tires when it was carbarated, and has been a sitting in my grarage since 98.
Health reasons force the sale :-( I have put a ton!! of time and money in the car! It only has 300 miles on the rebuild on the motor. You would be hard pressed to find a cleaner 84 around!
Please e-mail me at cujo2001gt@hotmail.com for any other info or pics , thanks Joe
I have well over $18,000 invested in it will let go for $3900, serious only please
 
See less See more
You have insufficient privileges to reply here.
Top