1985 Mustang Coupe/ 460 engine - Ford Mustang Forums : Corral.net Mustang Forum
 
LinkBack Thread Tools Display Modes
post #1 of 7 Old 10-14-2007, 07:21 AM Thread Starter
Registered User
 
Trader Feedback: (1)
Join Date: Feb 2002
Location: Carolina
Posts: 137
1985 Mustang Coupe/ 460 engine

I built this car to race but then didn't have the time. I then decided I was going to convert it to street but still don't have the time so the car has been sitting for 2 years (I do start it and drive it up the street every couple of weeks).To get it street legal you will need to install the wiring harness which I have that was removed from a 81 Mustang, the exhaust which is 3 1/2" Dynomax race bullet mufflers with 3 1/2" pipes and down turns that I also have, a Autometer speedometer which also comes with the car, it has a windshield wiper assembly that needs to be installed, and it has all the mirrors that will need to be painted and installed. All you will need is turn signal switch, headlight switch, and speedometer cable.The only thing I have as far as a title go's is a registration from the state of Maine which I was assured would get me a NC title but I haven't tried.This is a VERY fast car that runs great.The car also now has MT ET Street tires on it instead of the slicks you see in the pictures. If you have any questions email me and also for a set of pics .Asking $4500 or best offer. Here is a list of what has been done to the car:
ENGINE:

1973 Ford 460
Bored .030 over 466 CI
Keith Black hyperutetic flat top pistons
Ford D6VE-AA truck rods/ Milodan rod bolts
Rotating assembly balanced
Clevite bearings through out engine
Comp Cams 292 Magnum Cam .560 .560 lift
Comp Cams double roller timing chain
Carter racing mechanical fuel pump
Accel Super Stock electronic breakerless distributor, mechanical advance / Accel SS coil
Moroso racing water pump and electric drive kit
Summit Racing HV oil pump
Ford Motorsports 6 qt oil pan
Canton crank scraper
Offenhauser Port-O-Sonic single plane intake
Holley 1050 Dominator #8082
Hooker Super Comp Headers
Holcomb motor mounts

Heads:

1968 Ford 429 heads C8VE-E
3 angle valve job
Ferrera 2.19 intake & 1.76 exhaust valves
Comp Cams Hyd. Lifters/ retainers/ valve springs
Crane Gold Race 1.73 roller rockers
ARP rocker studs and guide plates
Trick Flow chrome moly push rods
Ported and Polished

Rearend:

8.8 Ford out of 1990 GT Mustang
Moser 33 spline race axels/spool/C-clip eliminators
Motive 4.56 racing gears
Axle tubes welded
Mac rear cover
HPM adjustable upper control arms
Mac lower control arms
Lakewood 50/50 drag shocks
Competition Engineering drag springs with air bag

Transmission:

1973 C-6
Rebuilt with B&M Trans-Pak kit
Valve body converted to full manual shift
Dacco 3500 stall converter
Moroso transmission cooler


Misc:


Weld Draglites, sub frame connectors, B&M Z-Gate shifter, Hurst Line lock, Moroso cage mounted switch panel, S&W 10pt. cage, 90/10 Lakewood drag struts,Autogage gages, Lakewood driveshaft safety loop, RCI 5 gal. fuel cell, Northern 31x19 aluminum radiator, Proform 2000 cfm electric fan, Milodan valve covers,5” HO Fiber Trends cowl hood, fiberglass rear trunk lid, MT 28x10 drag slicks, Jacobs Fire Control 2000 ignition box with rev-limiter.


85'LX Coupe
466/C-6
4.56 Rear
JD466 is offline  
Sponsored Links
Advertisement
 
post #2 of 7 Old 10-18-2007, 08:38 AM
Registered User
 
weldonj's Avatar
 
Trader Feedback: (3)
Join Date: Oct 2005
Location: Fayetteville, NC
Posts: 311
pics to [email protected]
where are you in NC? I'm in Fayetteville

weldonj is offline  
post #3 of 7 Old 10-18-2007, 10:26 AM Thread Starter
Registered User
 
Trader Feedback: (1)
Join Date: Feb 2002
Location: Carolina
Posts: 137
I am located up 401 in Fuquay Varina.

85'LX Coupe
466/C-6
4.56 Rear
JD466 is offline  
Sponsored Links
Advertisement
 
post #4 of 7 Old 10-18-2007, 10:29 AM
Registered User
 
Trader Feedback: (0)
Join Date: Oct 2007
Location: Worcester, MA
Posts: 20
please send pictures to sccobra87 at yahoo
sccobra87 is offline  
post #5 of 7 Old 10-18-2007, 11:57 AM
 
Trader Feedback: (0)
Join Date: Oct 2007
Posts: 88
please send me some pics to [email protected]
twbnos is offline  
post #6 of 7 Old 10-22-2007, 09:33 PM
Registered User
 
Trader Feedback: (3)
Join Date: Jan 2006
Location: NC
Posts: 83
car

what et does the car run? hp? why havent you applied for a lost title? without a title it will be hard to make a street car out of.
fasttruck is offline  
post #7 of 7 Old 10-23-2007, 04:18 AM Thread Starter
Registered User
 
Trader Feedback: (1)
Join Date: Feb 2002
Location: Carolina
Posts: 137
Car is sold.

85'LX Coupe
466/C-6
4.56 Rear
JD466 is offline  
Sponsored Links
Advertisement
 
Reply

Bookmarks

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Ford Mustang Forums : Corral.net Mustang Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode



Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome