Ford Mustang Forums banner

looking for a low profile 4150 plate. shorter the better....

2K views 11 replies 4 participants last post by  boostdcoupe 
#1 ·
I had a mainline ml1000 kit back a couple of years ago and LOVED IT.

right now I am doing a Windsor this time instead of a 302based motor and trying to keep the height down so I can use a stock hood.

who makes the smallest plate that works good? I believe the mainline was a half inch 1/2inch. if that's the smallest out there then im buying another one from trey like I did off here the first time. SOB never sent me my NX hat but he still helped me out a bunch LOL!

thanks for the help with the questions guys...
 
#3 ·
Garrett from NX will probably respond today when he gets back to work. IIRC NOS cheater plates are fairly thin as well.
 
#12 ·
I would bet NX could plumb the intake with spraybars on both sides of the plenum Tee'd into one set of jet holders... that would be COOL!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top